Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Mm128
| Posted on Thursday, July 10, 2008 - 12:35 am: |
|
BIKE IS A 96 S1 SOLO TAIL I just replaced the WEST TECK lower brace for the shock BACK to the Original as it was set up for a SHORTER rider. I NEED to verify that the seat height is correct. CAN SOMEONE GIVE ME A MEASUREMENT FROM THE REAR TURN SIGNAL NUT TO THE AXLE NUT. I just want to make sure that my rear is back to the ORIGINAL height. Seems like its LOW but that could be due to me riding a XB9R. Thanks, Matt. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Akironic
| Posted on Sunday, July 20, 2008 - 01:17 pm: |
|
Haven't been in Old School in a while but, that sux everyone left you hangin. I'm gonna run out to the garage and get you that number right now. One sec....... From the center of the allen head bolt that mounts the turn signal to the center of the axle id 20-1/2'' |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Eshardball
| Posted on Sunday, July 27, 2008 - 03:10 pm: |
|
I measured 20.5" on my 98 S1 but it is not the solo tail. Hope that helps. |
|