Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Midnightrider
| Posted on Thursday, February 07, 2008 - 10:41 pm: |
|
Didn't need the "low" part but I wanted it for the gel pad. Found out I was happier with the stock seat and a "butt buffer" pad. Probably less than 100 miles on the saddle. I did, however, drill three 3/4 inch holes in the air dam underneath the seat when I was experimenting with heat flow issues. These have been plugged with threaded pvc fittings. No structural issues - just cosmetic. $125 |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Midnightrider
| Posted on Thursday, February 07, 2008 - 10:45 pm: |
|
this is an early pic when i wanted the air to flow through. i replaced the fittings with smaller black caps
![](http://www.badweatherbikers.com/buell/messages/21/335328.jpg)
|
|