Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Davo
| Posted on Monday, June 05, 2006 - 09:00 pm: |
|
I got stuck in traffic the other day and the Uly was running pretty hot so I turned off the engine and let her cool down. The fan finally went off and the traffic started to move again so I started the engine and had to wait until the ET reached 428 F before the fan would restart. I have an idea! What if I connected a circuit to pin 9 on the grey ECM connector through a push button switch then through a 200 ohm resister and then to ground. I could then start the fan by simply pushing the button for a second and then the ECM would think the engine was hot enough for the fan to turn on without waiting for 428 F. I know the fan would only continue to run if the engine temperature was above 356 F. Does anyone see any potential problems with my idea? |
|