G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Buell Forum » XBoard » Buell XBoard Archives » Anyone have this problem? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Socalxb
Posted on Sunday, April 23, 2006 - 09:33 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I've only had my 12R for about a month (bought it it used with about 1,300 miles on it) and this is the first problem I've encountered.

When I turn the ignition to "ON" the gauges swing around and the lights come on, but no fuel pump (I'm assuming that what the noise from down below is) and nothing when I hit the starter. The first time it happened I just turned the ignition back off and started over and it fired up fine. Today I tried this several times and got nothing. I pulled off the fuse cover, checked the fuses were good and tight and sure enough it came to life and started fine. When I stopped for gas I kept the ignition on and when it was time to go it started up again just fine. When I stopped for a break and turned it off again I got the same problem when I tried to leave. Messed with fuses again and after a few minutes the pump came to life and it started, but needless to say this isn't something I'm comfortable with.

Any suggestions as to what the problem might be?
Top of pagePrevious messageNext messageBottom of page Link to this message

Lonexb
Posted on Sunday, April 23, 2006 - 09:40 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

eddie

i had a similar problem. turned out to be one of my relays.

might be something to look at.

brian
(lonexb)
Top of pagePrevious messageNext messageBottom of page Link to this message

Kdan
Posted on Monday, April 24, 2006 - 12:21 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I had the same problem last year and it was a loose battery cable.
Top of pagePrevious messageNext messageBottom of page Link to this message

Buellistic
Posted on Monday, April 24, 2006 - 05:07 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

MURFEYS LAW tests:

Has phanton electrical problems because you do not keep the battery terminals
tight or replace the battery every two years ...

Fails the wiggle test when riding because you did not tye wrap the wiring so it does not move ...

You did not put electrical grease on the quick disconnet connections and the contacts corrode ...
Top of pagePrevious messageNext messageBottom of page Link to this message

New12r
Posted on Monday, April 24, 2006 - 02:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

If the relays are grey, replace all of them with the white ones, I had that problem reoccur on several occasions until the new relay came out.
Top of pagePrevious messageNext messageBottom of page Link to this message

Socalxb
Posted on Monday, April 24, 2006 - 05:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Are those relays something I would have to order?

And by the way, where are they? Thanks.

Eddie
Top of pagePrevious messageNext messageBottom of page Link to this message

Lonexb
Posted on Monday, April 24, 2006 - 08:55 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

eddie
the relays are in the other black fuse looking box.(oposite the fuse box in the front fairing.on the clutch side.)

your local dealer should have them. i think they cost $4 or $5 each.

if not give daves a call, and i am sure he can have them to you in a couple of days.

brian
(lonexb)
Top of pagePrevious messageNext messageBottom of page Link to this message

Duff24
Posted on Tuesday, April 25, 2006 - 07:40 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

yeah i've ended up replacing all of those relays over the past year or so. when they go bad, the bottom of the relay looks like it's melted. any known cause for this?
Top of pagePrevious messageNext messageBottom of page Link to this message

Socalxb
Posted on Sunday, April 30, 2006 - 03:08 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Swapped in new relays (white) yesterday and it seems to have cured the problem. They were $6 a piece at the dealer so I went ahead and just swapped all three and bought an extra to keep under the seat.

Thanks for the easy fix, guys.
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration