Author |
Message |
Tommy_k
| Posted on Thursday, September 01, 2005 - 09:40 pm: |
|
Hey there. I replaced my factory stalk mirrors with some CRG barends. My question is about the screw sockets remaining. Does the firebolt have them plugged with a factory screw, or does it use different control mounts that are socket-less? Looking for a solution to eliminate the obvious...and don't say put the stockers back in. TIA TK |
Mellow_yellow
| Posted on Thursday, September 01, 2005 - 09:57 pm: |
|
Tommy k- you can buy plastic hole plugs at any hardware store for about 10 cents each.I got mine at Ace Hardware.You can't tell there was ever a hole there! |
Rageonthedl
| Posted on Thursday, September 01, 2005 - 11:06 pm: |
|
go to the dealer and get the plugs that are for the Firebolt. |
Pa_xb9sx
| Posted on Friday, September 02, 2005 - 06:07 am: |
|
If the holes are the same as the XB9SX, you can use (2) Nissan push fasteners from Lowe's. Much less than a dollar for both. They are located near the screws, nuts, and bolts. |
Reepicheep
| Posted on Friday, September 02, 2005 - 09:33 am: |
|
If you want the dealer parts, they only list the right side one, just get two of them. Me and the parts guy spent a bit of time head scratching looking for the left one... which does not exist. Sounds like Lowes might be easier though. |
Tommy_k
| Posted on Friday, September 02, 2005 - 09:38 am: |
|
Thanks guys. Plastic hole plugs it is! Tom |
Tommy_k
| Posted on Friday, September 02, 2005 - 07:15 pm: |
|
Just an update. There happened to be a Firebolt at my dealer, and an '06 parts catalog. The plastic plugs are PN:N0001.B and were under a buck. Just an FYI. TK |
|