G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Motorcycle Forum » Quick Board Archives » Archive through April 23, 2004 » S1 Whirring Sound? « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Erics1
Posted on Sunday, April 18, 2004 - 07:26 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I just made a couple of changes to my 6,000+ mile S1, and I'm now hearing a whirring noise that I hadn't previously noticed. It doesn't matter whether the clutch is engaged or disengaged, whether or not the bike is in gear, or
whether or not it is moving. The pitch of the whirring sound seems related to engine RPM. I mostly notice it at low speed (or stopped) and lower RPMs (maybe at least partially because wind noise might drown it out at speed). I don't really hear it when the bike is first started, only after it's fully warmed up.

The changes I made at the same time were:
1) install the beefier primary chain tensioner
2) switch to synthetic oil (Mobil 1, automobile oil). I put 20/50 in both the engine and the primary case

I've rechecked the engine and primary fluid levels, the clutch adjustment, and the chain tensioner, and all seem fine. Actually, the bike is running great, I'd swear it shifts easier now than before the Mobil 1.

If anybody has experience with this scenario, I'd appreciate a word of advice.

Thanks,
Eric Diehl
Top of pagePrevious messageNext messageBottom of page Link to this message

Newfie_buell
Posted on Sunday, April 18, 2004 - 09:18 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Primary Chain is probably too tight.
Top of pagePrevious messageNext messageBottom of page Link to this message

Spiderman
Posted on Sunday, April 18, 2004 - 11:08 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

Bingo
Top of pagePrevious messageNext messageBottom of page Link to this message

Newfie_buell
Posted on Sunday, April 18, 2004 - 05:08 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

YES,

Thought I was right!!
Top of pagePrevious messageNext messageBottom of page Link to this message

Erics1
Posted on Sunday, April 18, 2004 - 07:35 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

You were right. The chain definitely didn't seem too tight, around 3/8 inch play. But when I gave it a scootch more play - voila!

Maybe the chain tightens up a little when it comes up to full engine temperature..
Thanks
Top of pagePrevious messageNext messageBottom of page Link to this message

Spiderman
Posted on Sunday, April 18, 2004 - 10:02 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

That an a few spots run tighter than others, it is always a good idea to measure it in a few spots
Top of pagePrevious messageNext messageBottom of page Link to this message

Smadd
Posted on Monday, April 19, 2004 - 09:05 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only)

I always remove the plugs, put the rear on stands and shift into fourth gear. You can turn over the motor by rotating the rear wheel... and check/adjust in numerous spots along the chain. I've noticed quite a difference in different spots. Check carefully until you're sure you find the tightest spot... then do the adjustment... then recheck. Mine seems a little sloppy (too loose) in spots... but it's been like that for a long time and doesn't seem to cause problems.

Steve

edited by smadd on April 19, 2004
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a private posting area. Only registered users and custodians may post messages here.
Password:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration