G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Author Message   Fabfun Posted on Friday, June 08, 2018 - 01:38 pm:        How can I remove without the special tool so I can replace bearings?   Upthemaiden Posted on Friday, June 08, 2018 - 02:43 pm:        Is your swingarm one of the ones that has the threaded fitting to tighten the swingarm, or does it have the long 1/4" bolt that runs from one side to the other? I recently found out there was 2 different setups to adjust the swingarm. Someone here just dealt with that a month or two ago. If you search your might be able to find it. Mine has the long bolt, so I'm not entirely sure what yours looks like to be able to help.   Upthemaiden Posted on Friday, June 08, 2018 - 02:58 pm:        I looked in the tool section of the service manual. I'm guessing this is the tool you're referring to?   Fabfun Posted on Friday, June 08, 2018 - 03:02 pm:        Looks like this but no slot in the end   Fabfun Posted on Friday, June 08, 2018 - 06:17 pm:        I figured it out it has a long 1/4 inch bolt holding it in place

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a private posting area. Only registered users and custodians may post messages here. Password: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: