| Author | Message | ||
     Ft_bstrd |
Ordered bearings for the rear wheel. Received two LH and one RH. Am I correct that the two LH go on the drive side and the other on the brake rotor side? Or Does the thick one and one of the thin ones go on the drive side and the other thin one on the brake rotor side? Or Does the thick one go on the Brake Rotor side and the two thin ones go on the drive side? Thanks | ||
| Johnod |
Yes. | ||
| 1313 |
 | ||
| Ft_bstrd |
I have that diagram, but it doesn't explain which sized bearings go where. I think there may, in fact, be three different sizes. Just trying to figure out which ones go where. | ||
| 651lance |
The two narrow bearing should go the sprocket side and the single wide one will be on the brake side. | ||
| Ft_bstrd |
Guess I could have just called.  | ||
| Mighty_mouse |
You also would have found out when you went to disassemble the wheel. | ||
| Ratbuell |
Or when you see that the diagram shows (2) of #7, on the same side of the wheel... | ||
| Ft_bstrd |
I know that there are two on one side and one on the other. The problem is that the digram doesn't tell me which side the fat one goes on. (Message edited by ft bstrd on April 28, 2017) | ||
| Johnod |
I don't know how it can be made any clearer at this point. | ||
| Ratbuell |
There are (2) #7 bearings on one side. Same part. Same size. Together. There is (1) #14 bearing on the other side. Different part. By itself. The two that match go together. The one that's different goes on the other side. | ||
| Ft_bstrd |
Thanks everyone. |
