Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Gmaan03
| Posted on Sunday, December 09, 2012 - 06:27 pm: |
|
My second gear jumps out, so I pulled the tranny to check it out. The drive dogs look good but the shifting forks look bad. Wear marks and burrs from rubbing. I am going to do the shifter drum modification but can not find the thread, help? Also I am going to buy new shift forks, any other things I should look for??? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Harleyelf
| Posted on Sunday, December 09, 2012 - 07:29 pm: |
|
A recent thread found one of the pins that ride in the shift drum grooves was over-length. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Thejosh
| Posted on Sunday, December 09, 2012 - 07:40 pm: |
|
Look for shift drum, or hard shifting. I recently did the mod. All you need are snap ring pliers, a torque wrench that will go to 250 ft lbs, standard tools. If you already have the trans out, remove the drum and have a machinist cut the shift pawl shaft right below the notch then have him tap it with a 10/32. |
|