Author |
Message |
Dan9460
| Posted on Tuesday, July 27, 2010 - 07:07 pm: |
|
Occasionally when I let the clutch out I get a squeal almost as if I had popped the clutch and spun the rear wheel (I know I didn't do that because rpms are low)..any ideas - clutch works well, trans shifts smooth etc..running formula plus primary fluid. 1997 S1 thanks in advance |
Buellistic
| Posted on Tuesday, July 27, 2010 - 07:26 pm: |
|
Have you replaced the SPRING PLATE(aka GRENADE PLATE) PN37977-90 with two steel and one fiber plates yet ??? |
Dan9460
| Posted on Tuesday, July 27, 2010 - 07:43 pm: |
|
I am not sure - haven't been into it yet..was planning on the kit from American sportbike (5491 includes 8 steel plates and 9 Friction plates for an additional 12% more friction area) http://www.americansportbike.com/shoponline/ccp0-prodshow/5490.html But wanted to be sure if what the fix was? (Message edited by dan9460 on July 27, 2010) |
Mick
| Posted on Tuesday, July 27, 2010 - 08:02 pm: |
|
May be the belt , I get that occasionally when its cold. |
Buellistic
| Posted on Tuesday, July 27, 2010 - 08:22 pm: |
|
Al has good stuff !!! While you are in there replace BEARNG(like a throw out bearing on a STD. CAR/TRK TRANS) PN 8885 ... Check the PINS on SHIFTER DRUM ASM. PN 33634-91 for looseness(all should be tight) ... Take a good look(check out) the SHIFTER SHAFT ASSEMBLY(wear on PLATE,detent and up-date to PN 33656-90A), looseness, and the RETAINING RING(clip) PN 1101ness ... If you want some HELP "INFO", PM me so that "i" can get your e-mail address and it is yours ... |
Dan9460
| Posted on Tuesday, July 27, 2010 - 08:25 pm: |
|
Thank you so much pm sent |
|