Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Phelan
| Posted on Sunday, June 28, 2009 - 09:52 pm: |
|
The bolt spacing on the tube frame Buell front calipers is the same as the '84-'99 Harleys. I wonder if this means that the 6-piston Thunderheart caliper I picked up for my dad's FXD will fit on my S2? I didn't have time to take the old caliper off and try, but I did measure the holes spacing and it is the same... (Message edited by Phelan on June 29, 2009) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Texastechx1
| Posted on Sunday, June 28, 2009 - 10:36 pm: |
|
diameter of rotor and alignment of rotor and caliper would be the next things to measure... there only one way to find out. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Pkforbes87
| Posted on Sunday, June 28, 2009 - 11:21 pm: |
|
would be nice to find a caliper that is a bolt-on fit with the brembo rotor. (10mm smaller diameter than stock) Yeah I know - custom caliper mount. But a bolt on caliper would be so much easier, and IMO would make the install look a lot cleaner with fewer necessary parts. |
|