Author |
Message |
Rde48
| Posted on Friday, April 24, 2009 - 12:50 pm: |
|
I have to adjust my shift paw and I don't know what a NO 32 bit is. So I want to know what size but this is because all of my bits are standard. It may be a stupid question but you can try a yahoo search and get the crap that I got too. |
Jmkybf
| Posted on Friday, April 24, 2009 - 12:57 pm: |
|
It is .1160" diameter. |
Gowindward
| Posted on Friday, April 24, 2009 - 12:57 pm: |
|
.116" and No. 32 drill is the tap drill for a No. 6 course thread machine screw |
Rotzaruck
| Posted on Friday, April 24, 2009 - 01:02 pm: |
|
http://www.csgnetwork.com/drillsizeconvert.html Future reference |
Sloppy
| Posted on Friday, April 24, 2009 - 01:35 pm: |
|
If you have a caliper you can wrap electrical tape around a smaller size bit to get to the diameter that you need... just need to make sure you minimize any "squish" of the electrical tape. |
Akbuell
| Posted on Friday, April 24, 2009 - 03:42 pm: |
|
Check local hardware stores, and ask for one. Many have numbered drill bits, but don't hang them on the wall w/the fractional stuff. |
Buelleaver
| Posted on Friday, April 24, 2009 - 09:51 pm: |
|
or standard 3 mm is close @ .118 |
|