| Author | Message | ||
     Scott_in_nh |
I am polishing my swingarm while I am waiting for the new belt and isolators to come in. The bearings and races are in good shape but I need new seals. These look pretty generic but I do not see any numbers on them that would help me source them locally. Suggestions? Is there a HD version of 47584-94Y (Buell seal pn)? The HD dealer is much closer than the nearest Buell dealer.... Thanks | ||
| Ratbuell |
Your HD dealer should be able to order the Buell PN, they're all in the parts download for the computer systems. | ||
| Werewulf |
i tried to order buell parts from zanotti at twenty percent off..they said they cant order buell parts, because they are a harley only dealer.. | ||
| Scott_in_nh |
Thanks, but I wouldn't order parts anyway. To many cases of mis-ordered, back ordered and non-ordered parts. I am hoping to find them on the shelf locally, otherwise I will buy them from one of the fine sponsors here who has them on the shelf. | ||
| Sloppy |
HD shops can ONLY buy Buell parts if they are a Buell dealer. Even if the parts cary an HD number... Go with the Sponsers here. I've had great service from Colin at Hal's. | ||
| Ducxl |
I have a spare set of those seals on my shelf.I bought two sets when i did them in case i tweaked a seal i still had spare new ones.Lemme know if you have trouble sourcing them | ||
| Scott_in_nh |
Thanks Greg, there is a bearing shop across the street I'll try 1st and then check with Manchester HD. If they don't have stock, then I will take you up on your offer! | ||
| 99cyclone |
I don't know about the cast aluminum swingarm seals, but the seals for the steel swingarms can be purchased at nearly any auto parts store. The seals have a p/n stamped in them. I just took mine in to O'Reilly's and picked up the exact replacements. Only cost a little over $2 each! | ||
| Scott_in_nh |
they probably are the same 99, and the auto store equivalent is what I was hoping for, but for some reason I don't have any numbers stamped on mine? Greg are there any numbers on the ones you're holding? | ||
| Ducxl |
Only on the Buell package,P/N FA3850.5 My bearing tools  | ||
| Cyclonemduece |
go to a place that works on and or rebuilds trannys and rear ends, i went to a place like that, they measured em and gave me new ones for a dollar!! | ||
| 99cyclone |
OK...here's the numbers and dimensions for the seal used on the steel swingarm bikes. You can compare it to yours. The National Seal part number is 443018. The dimensions are: Seal ID: 1.500" Bore Dia: 1.984" Seal Width: 0.188" | ||
| Scott_in_nh |
Thanks 99!! I'll post what I find out.... | ||
| Ducxl |
So you have the same swingarm as me. From the parts catalogue: page#51/52 items#31&29 respectively P/N 48430-99y dust seal (you need at least 2) P/N 48300 roller bearing w/cup for two A decent outer bearing race driver,a seal puller(fancy tool with a hook to pull seals).The seal tool is at any auto parts store at about $5. pm sent | ||
| Scott_in_nh |
I measured my seals and they are the same dimensions as the steel swingarm seals. Thanks for posting the dimensions. | ||
| Scott_in_nh |
Eastern Bearings across the street from my work is hooking me up with bearings and seals!  | ||
| Ducxl |
Just an FYI>>>>here they are |
