| Author | Message | ||
     Cyclonemduece |
I have a 2k m2 and i am going to use the headlight off of an XB-S. I have three wires on my m2's harness, I am going to assume without looking at my service manual that they are a ground, high beam and low beam. The XB-S lights are dual and the have more posts for wires, two per bulb thus four total. My question is how to wires these so i have both lights on at the same time, full time. I seen that spiderman has put these lights on his bike, are you still around here?? thanks BLAKE | ||
| Werewulf |
http://www.hdforums.com/upfiles/2318/D34F900EEB514 ECD8BDE7D03082FD0FB.gif | ||
| Cyclonemduece |
i look at that and say, ahhhhhh. OK i have buddy who is an electrician, maybe he will know what to. | ||
| Bad_karma |
Think about ground to each and High beam to each that allows you to turn the light off during low voltage situations. Only draw back is state inspection? Joe | ||
| Firemanjim |
Not sure on your bike but the Uly' have 4 wires going to em, 1 low, one hi, one is an International wire--we swap this to low so it does not go off when high beam comes on. | ||
| Cyclonemduece |
whats an international wire |
