Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jmccarthy
| Posted on Tuesday, May 13, 2014 - 04:39 pm: |
|
Buell Blast 03 will start up, but the engine will die when the handlebars are turned to the right. This is the only thing that I have found loose on the bike, any suggestions as to what this is or where it's supposed to go? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Natexlh1000
| Posted on Tuesday, May 13, 2014 - 06:57 pm: |
|
I'll need a better pic to guess better. My guess is that's supposed to go to the oil pressure sensor. does the oil light come on if the wire is shorted to ground? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Two_seasons
| Posted on Tuesday, May 13, 2014 - 10:09 pm: |
|
You'll need to go into your wiring harness. As our bikes age, the insulation becomes brittle, and the wires are pulled apart within the insulation. More than likely, you'll find a wire(s) that has a separation in the copper within the insulation. Check your ignition wiring too. |
|