Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Affatbe
| Posted on Monday, October 21, 2013 - 09:14 am: |
|
my bike was running rough and over heating so I did a complete tare down and replace a broken oil jet. while I had the bike down I swapped to xb9 domed pistons. The bike still has a rough idle but no longer over heating :-). I spoke with some people about the idle and bue to the increase to compression they suggested the gap may be different for the new pistons and I should run a cooler plug. Anyone have insight on this or done it themselves? All the research I have done is the 9's and 12's have the same recommended gap and plug so not sure if this would even help. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Affatbe
| Posted on Monday, October 21, 2013 - 10:04 am: |
|
![](http://www.badweatherbikers.com/buell/messages/3842/724607.jpg)
![](http://www.badweatherbikers.com/buell/messages/3842/724608.jpg)
|
|