Author |
Message |
Flexx
| Posted on Friday, October 14, 2011 - 12:05 pm: |
|
Thank you two season, then I'll esxercise them |
Akbuell
| Posted on Tuesday, October 18, 2011 - 02:20 pm: |
|
PM sent |
Flexx
| Posted on Friday, October 28, 2011 - 08:59 am: |
|
Hi guys. So, it's probably the black wire of the TPS sensor. In the next days I will try to understand where it's supposed to get to ground. Thank you all! |
Two_seasons
| Posted on Friday, October 28, 2011 - 10:12 am: |
|
Sometimes it is that easy to fix. The difficult part of problems usually is the troubleshooting. Connector 88A is your TPS connector. The Black/White terminal, as you have indicated, is your TPS sensor ground. Terminal C is the black/white wire. That wire is also terminated at two locations. 1.) Connector 14, terminal C which goes to your Cam Position Sensor and 2.) Connector 11, Pin 7 at your ECM. Make sure that these other two terminations are listed above are getting a solid ground too. There has been talk on this board that at the Cam Position Sensor the wires are sometimes chaffed (insulation broken down and wire(s) shorted to ground). Ensure that your CPS wire loom under the CPS cover is not chaffed. Let us know what you find and if that fixes your bike problems. |
Akbuell
| Posted on Tuesday, November 08, 2011 - 03:23 pm: |
|
How goes it? Success I hope. Did you find the problem? |
|