Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Deanh8
| Posted on Friday, September 30, 2011 - 07:02 pm: |
|
I torqued my heads down and noticed a crack in my pushrod cover from when my pushrod bent. I need to take them off and replace it but do I need new gaskets? I never started the bike. Do they seal once torqued? Also if I buy an OEM ring set do they need to be gapped or are they ready to go from the factory. The cylinders are stock unbored and untouched |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Pammy
| Posted on Thursday, October 06, 2011 - 09:49 am: |
|
You can use the gaskets again. Always check the ring end gap, but it will probably be sufficient. It only takes a few minutes. |
|