G oog le BadWeB | Login/out | Topics | Search | Custodians | Register | Edit Profile

Author Message   Artur Posted on Tuesday, September 15, 2009 - 03:01 pm:        Here what it looks like after removing the primary cover (to do that I followed the service manual). To be able to move on I fabricated my own Sprocket Locking Tool: Then I unscrewed the Engine Sprocket nut: Then I removed the Retaining Ring and Adjusting Screw Assembly: and unscrewed the Clutch Shell with Clutch Sprocket: Then I removed the Engine Sprocket, Clutch Shell with Sprocket and the Primary Chain. It turned out that the Engine Sprocket is attached to the Alternator Rotor Assembly: I unscrewed the Engine Sprocket from the Rotor Assembly: but they stick to each other really hard and I cannot split them. Here is what the manual says about how to remove the sprocket from the rotor: As I don't have the press, I took the rotor to the garage to get the engine sprockets swapped. Once it's done I'll continue with my work and my writeup.   Luckyrainman Posted on Thursday, September 17, 2009 - 08:06 am:        Does anybody know the NEW part numbers of the improved 2008/2009 Primary Sprocket with screw and washer? Buell changed these parts and i am searching for the information ... Thanks a lot!   Blake Posted on Thursday, September 17, 2009 - 05:45 pm:        Part numbers for 2009 Buell XBike primary sprocket (Alternator Rotor & Sprocket Assembly) are: XB9 Alternator Rotor & 34 Tooth Sprocket Assembly: 30018-08 (entire assembly including alternator rotor 8 screws and 34 tooth sprocket) XB12 Alternator Rotor & 38 Tooth Sprocket Assembly: 30029-08 (entire assembly including alternator rotor 8 screws and 38 tooth sprocket) There is no part number in my parts book for just the sprocket.   Artur Posted on Sunday, September 20, 2009 - 06:49 am:        Here is the rest of the story: http://www.buellxb.com/Buell-XB-Forum/Do-It-Yourse lf-Buell-Mods/DIY-primary-gearing-swap-step-by-ste p-with-pics   Dthquazi Posted on Thursday, November 19, 2009 - 04:11 am:        I am wondering if you are able to get the clutch hub off without the clutch packet put together. I had a wreck and need to get it off but dont have any of the 8 guide pieces left. Any ideas?   V74 Posted on Thursday, November 19, 2009 - 05:46 am:        is it possible to put the 34 tooth sprocket on a tube frame buell? i have a uk geared M2 and want to lower the gearing a bit,this would do it with out needing too recalibrate the speedo,   Goody Posted on Thursday, December 10, 2009 - 09:49 pm:        I have this mod on my XB12STT....Awesome!!

Add Your Message Here Post: -Color- Black Red Green Blue Yellow Purple Orange Cyan Gray White -Font- Arial Courier Symbol Times Verdana -Size- Smallest (-2) Small (-1) Normal Large (+1) Largest (+2) Username: Posting Information: This is a private posting area. Only registered users and custodians may post messages here. Password: Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.) Enable HTML code in message Automatically activate URLs in message Action: