| Author | Message | ||
     Lllbmanlll |
Here's the part # for the bars: N1002.1AT2T Anyone try to get these bars to work on a XB12S? Are these bars actually lower than the XB12S bars? Are they the same diameter? I want to have a lower bar but would like to keep the bar diameter the same since I'm using a GPR stabilizer with their custom upper bar clamp that is made for the original size bar. Any help would be appreciated. (Message edited by lllbmanlll on February 14, 2009) (Message edited by lllbmanlll on February 14, 2009) | ||
| Al_lighton |
It's a 1-1/8" bar, so it won't help you. I'm sure they're lower than the XB-S bars, but I can't say by how much. Al | ||
| Lllbmanlll |
Thanks Al! What size are the original bars? | ||
| Al_lighton |
7/8" The CR bars are 7/8" where the controls are, just like XB bars. But XB bars are 7/8" for their entire length, CR bars taper from 1-1/8" in the clamp area to 7/8" in the grip area. The CR bars CAN be mounted with the 1-1/8" adapters. We have the precision engineering 1-1/8" bar moutns in stock, but there is a small issue with them that we are currently resolving. Al | ||
| Lllbmanlll |
Thanks for the thorough information Al. |
