| Author |
Message |
    
Johneeoxford
| | Posted on Friday, August 08, 2008 - 10:42 am: | 
|
So I was told that my bike was runnin too lean, causing the vibration I was describing in my other thread. I got a guy in Florida whos settin up the ECM for it to run better, after I get it back, do I need to have a TPS reset? I have the service manual and I dont see anything about it unless Im missing something. . . which I probably am.
The only thing Im upgrading is from stock air filter to a K&N, stock pipe, no other mods
(Message edited by johneeoxford on August 08, 2008) |
Ccryder
| | Posted on Friday, August 08, 2008 - 12:18 pm: |
|
You can probably get by w/o resetting the TPS, depending on how much the FL guy reset. Try it and see. If it doesn't run good then try a TPS reset. If you don't have the correct cable and ECMspy then you need to get your Dealer to do the TPS reset. See if there are any Buelligans around your area that can help. |
Johneeoxford
| | Posted on Friday, August 08, 2008 - 03:27 pm: |
|
The guy I dropped the brain off with said he could do the reset, but most probably wouldnt need t. we'll see. I think I'm the only one in my area Buell ridin.  |
Ccryder
| | Posted on Friday, August 08, 2008 - 03:40 pm: |
|
I don't know your area but it would really surprise me if there were not other Buelligans in your area.
Try posting in the General Discussion Board and Storm Fronts to see if anyone will bite and might be able to help you.
Later. |
Johneeoxford
| | Posted on Friday, August 08, 2008 - 04:32 pm: |
|
thanks! will do. |
|
Troubleshooting (Poor Starting/Running/Handling/Ride Issues) »
Archive through September 10, 2008 »
Removed the ECM. . . TPS reset?