Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jester8609
| Posted on Saturday, November 11, 2006 - 03:28 pm: |
|
I backed into a pole knocking my rear blinker off!! when I plugged it back in the signal was on blinking rapidly. As soon as I plugged it in the blinker stopped and now neither side works. No light on dash absolutely nothin. Fuses are all good. So anyone have a clue?? Thanks Jeff}} |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Blake
| Posted on Saturday, November 11, 2006 - 06:55 pm: |
|
What happens when you remove the previously knocked off blinker? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Lost_in_ohio
| Posted on Sunday, November 12, 2006 - 11:45 am: |
|
Sounds like a short that may have taken out your blinker relay. A fuse will not save a component just prevent a fire for the most part. I would take a volt ohm meter and check to make sure that the signal you knocked off is not shorted to ground. and then check an make sure you have voltage to the signal relay. If you want more help let me know model and such I can pull out the book and get wire colors and such. (Message edited by lost_in_ohio on November 12, 2006) |
|