Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Billp
| Posted on Sunday, August 28, 2016 - 09:23 am: |
|
After an oil change yesterday one of my lower faring screws would not go in and I did not want to force it. All the others went in without any problems I suspect that I have to chase the threads in the hole but I do not know what size tap to use. Does anybody know what size this is ? |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Reepicheep
| Posted on Sunday, August 28, 2016 - 09:43 am: |
|
That's pretty common, I just did exactly that last weekend (again). I forget which tap I had to use, but I am pretty sure I went over and grabbed it from the SAE box, not the metric box. It's a very common size. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Teeps
| Posted on Sunday, August 28, 2016 - 10:38 am: |
|
Yes it's SAE; 1/4-20. |
|