Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Sugarmcguinnmsncom
| Posted on Saturday, October 12, 2013 - 07:32 pm: |
|
I've been searching all over for this... Here (Knowledge Vault), there (inter-webs), the service manual... No dice... I read somewhere that it was 8.3, but the thread seemed unsure, at best... Anyone have a definitive answer on this? Thanks. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Ericz
| Posted on Sunday, October 13, 2013 - 06:01 pm: |
|
Wheel valve stem or cylinder head valve stem? Cylinder head valve stems are 7mm. I have a wheel valve stem I could measure if you need. (Message edited by EricZ on October 13, 2013) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Sugarmcguinnmsncom
| Posted on Sunday, October 13, 2013 - 07:46 pm: |
|
Sorry, my bad... Wheel Valve stem. I actually went out and threw a caliper on the wheel... It is in fact 8.3mm. Any idea on the proper length? |
|