| Author | Message | ||
     Ripdog28 |
I added a D&D pipe a while back and it ran OK with the stock ECM but it has a stumble in the 3k range. I just put a EBR D&D ECM and an open air box on it. After a few short rides and a good 30 min ride above 3k it seemed to run better when i would pull hard from 3k but if i accelerate slow it stumbles several times from 3-4k then is fine. This is really noticable in 3rd gear but not really noticable in any other gear. not sure what it is at this point. I have 20k on it and no problems except the stumble. | ||
| Xoptimizedrsx |
cylinder offset in the fuel mapping. your bike is asking for more on one and less on the other in that cell area to refine it a tad further. You can fine tune it with a couple datalogs. | ||
| Ripdog28 |
Thanks Xopti, That is what I thought is it needed a few long rides. Should I ride in the area of the problem, 3rd/3-4k? or just 5th above 3k? |
