Author |
Message |
Gater
| Posted on Saturday, October 09, 2010 - 09:42 am: |
|
My XB12S Failed inspection because the rear break leaver when pressed would not light up the rear break light apparently I was not pressing hard enough. I went home and pressed hard on the leaver and it lit up. The front break leaver is fine. Is there a way to adjust the sensitivity of the switch that lights up the break light when you press the rear break leaver? |
Greg_e
| Posted on Saturday, October 09, 2010 - 12:04 pm: |
|
Sounds like you either have an air bubble in the line or a failing switch. The switch is pressure activated. I suggest bleeding the system and trying again. If not then tell them to press hard because the back break has a really low ratio between the two pistons so it was designed to be stomped on to make it work. |
|