Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Yool
| Posted on Friday, June 04, 2010 - 09:44 pm: |
|
Hi guys, I'm a newbie here, great board, and found a lot of info. I've scored a buell race muffler for my XB12. I currently have a '07 airbox, KN Filter and custom 2" exhaust all the way through. My custom map has been dyno,d to suit this set-up. Do you think I should buy a race ECM? Or just re-map the stock again. Dyno time would run to about the same price as a 2nd hand race ECM I can get. (Message edited by yool on June 04, 2010) |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Froggy
| Posted on Friday, June 04, 2010 - 10:05 pm: |
|
Personally I would leave it as is, sure you could tune it to squeeze every last ounce out of the difference pipe but it should run good regardless. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Yool
| Posted on Sunday, June 06, 2010 - 04:53 am: |
|
Thanks for the advice, Froggy. I fitted the exhaust today, went for a short ride, laptop under the seat, just in case of problems. You were spot on, bike ran fine, and SOUNDS SO SWEET![](http://www.badweatherbikers.com/buell/clipart/biggrin3d.gif) |
|