| Author | Message | ||
     Drkside79 |
So i finally ordered an XB Light and a fender eliminator. So is the tail piece difficult to remove or is it a few screws and pull. Thanks as always! | ||
| Andymnelson |
Not bad, there's a bunch of screws, but all are pretty obvious. The ones inside the tail are bit of a b**** to get out without the right tool, but otherwise no big deal. You'll love the light! Which option did you get? | ||
| Drkside79 |
#1 I have no interest in integrated signals(I just don't trust them to be seen especially while breaking) | ||
| California69gs |
nah it's super easy, even I could do it! | ||
| Andymnelson |
Cool, that's what I went with. My fiance now rides the XB, so it has #1 with Kellerman Micro1000 LED turns- RIDICULOUSLY bright at the back end now! | ||
| Rah7777777 |
Two T27 torx right above your rear wheel, 4 Allens holding the rear piece on ( I want to say 5mm allens, but really can't remember ) and your tail light and stock license plate electrical connections and it should all come off. Pretty simple. You will LOVE the difference in looks! Really cleans our little XB's up! Thanks again! And double thanks to all the kind words above! -Robert www.xblights.com |
