| Author | Message | ||
     Tq_freak |
The turn signals stopped working on my 12S this week and was trying to figure it out. Well I pulled the pins out of the connector for the flasher to check for corrosion / wire breaks and told my self "don't forget the order" well I did. If some one could just take a snapshot of a diagram of which wire goes where I would be more then appreciative. Side note, I figured it out, the LED flasher went bad. No wire breaks and every circuit has continuity. Flasher stops / Stars working when wiggled . Also I looked in the service manual, there isn't a detailed picture of the plug (Message edited by tq_freak on September 12, 2009) | ||
| Evil_mechanic |
Hope this helps.   | ||
| Tq_freak |
Score!!! Thanx I owe you one | ||
| Evil_mechanic |
No problem mang! |
