| Author | Message | ||
     Dthquazi |
I keep searching around the BADWEB but keep finding the same info about cable issues. I would like to find where(links) and prices for the bars people are using and the spacers that are working for them so I can see different options. I think out of all of them I like the 1125CR bars the best, but the price seems to be the worst. | ||
| Xl_cheese |
Look down a lil ways and you'll see my thread. Also check the classifieds for my cr clubmans with adapters for sale. http://www.badweatherbikers.com/buell/messages/327 77/476390.html?1248571767 They work great, but were to aggressive for my taste. http://www.badweatherbikers.com/buell/messages/21/ 480625.html?1248368994 | ||
| Jraice |
I love mine. Xl's thread is good for routing. Brake fit no problem, throttle fit but had to be routed a little differently and the control (see Xl's pic's) switch had to be rotated. Clutch as a pain, I had to remove the front screen and feed it into the front section and then drill a hole to get it to route to the clutch. Unfortunetly my first (and second) hole's were not in the right spot so I now have a rather large amount of metal drilled out, but its all under the cable and nearly invisible unless you are looking at the routing. Sometime if I really wanted to I could probably fill it in with a small fiberglass patch, some filler and black paint and redo it but I am fine for now. | ||
| Dthquazi |
Do you have links to where you got your parts for the set up? Also some pics of your bar and risers you used? | ||
| Jraice |
Xl has pics of the setup... The bars I got from Buell, I got them for much less then the $139 they go for but thats what you'll likely have to pay unless you have a good relationship with your dealer as well, and they happen to have a set laying around. The riser company is in Xl's thread I am sure, its either precision engineering or performance engineering. I cant remember. They are 1" risers to allow the bars to clear and give you a little more height, and then they also allow you to use the CR bar's larger diameter (at the mounting point). Also on a side note, I found that installing the CR bar so its installation guide line was perfectly matched up with the point where the two halves of the clamp adapters meet up was just the right angle. |
