Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Buplaux
| Posted on Wednesday, September 24, 2008 - 11:06 am: |
|
The tuning part seems to be pretty straight forward. I want to know if most leave the Wideband o2 in for everyday operations or do you have to switch back to NB. Also I have done a lot of data logging and have got my maps really smooth even below 2000 rpm (nb o2 in the front pipe also). Do I really need a wideband or can you get close enough with the NB with a lot of data logging????? Thanks, Jeff |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Hogs
| Posted on Wednesday, September 24, 2008 - 11:17 am: |
|
Not sure on that, However I do believe ya have to keep power to the WIDE baND 02 SENSOR WHEN INSTALLED OR, dRIVING WITH IT WITH NO POWER ON IS A NO NO FOR wb. bURNS THEM OUT OR DOES SOMETHING TO THEM?? pERHAPS OTHERS KNOW MORE ON THIS... Sorry about da caps..Key Board screwing up |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Jerseyguy
| Posted on Wednesday, September 24, 2008 - 01:07 pm: |
|
The Buell ECM can't use a wideband O2 sensor, unless there's some electronic adapter in between. To use my Innovative data acquisition system, I put a bung in the collector and put a wideband sensor there. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Od54
| Posted on Wednesday, September 24, 2008 - 01:23 pm: |
|
Wide band is a must for accurate data logging. Narrow band sensors take too long to adjust to changes. If your wide band driver has a narrow band output just use that. |
|