Author |
Message |
Petermcnair86
| Posted on Sunday, August 12, 2018 - 11:08 am: |
|
Like the title says, the fans and fuel pump keep activating after the bike is off. This will go on for a good 20 minutes. I understand that the fans will stay on for a second after you turn the bike off, but I don't think it's meant to keep turning on and off for xx amount of time? Troubleshooting: - I disconnected and reconnected the battery to see if that would do anything, but as soon as I started the bike again, it continues. -removed and reinserted the fuze for the fuel pump, and this worked, until the bike was started again. Video of the issue is included. https://youtu.be/R512GxACXfM |
Desert_bird
| Posted on Sunday, August 12, 2018 - 12:04 pm: |
|
McNair, It's normal for the 1125R. Just the bike taking care of itself: The fuel pump will cycle for a while when you turn it off on a warm engine. I believe the objective is to maintain pressure in the fuel line to facilitate start up. The cycling should stop once the bike cools down below a certain threshold. DB |
Petermcnair86
| Posted on Sunday, August 12, 2018 - 03:00 pm: |
|
Thanks, I was just concerned that it would drain the battery or something. |
Barraspalding
| Posted on Sunday, August 12, 2018 - 07:03 pm: |
|
No doubt it would pull from the battery, not sure to what degree. If you are able to kick over after this occurs than its no issue. |
Froggy
| Posted on Sunday, August 12, 2018 - 07:35 pm: |
|
The ECM programming for the fan and fuel pump has a low voltage cutoff, so assuming your battery is healthy it won't discharge to the point you can't restart. |
Thefleshrocket
| Posted on Thursday, September 06, 2018 - 09:29 am: |
|
I disabled the fans on after key off when my 1125R had a weak battery (it didn't take much to suck down the battery enough that the bike had problems starting) and left it that way, with no ill effects. |
Dannybuell
| Posted on Thursday, September 06, 2018 - 10:19 am: |
|
How Did You Disable The Fans? |
Thefleshrocket
| Posted on Thursday, September 06, 2018 - 11:56 am: |
|
Oh heck, I don't remember off the top of my head. It was an options somewhere in the tune file--I don't remember it being hard to find. I have it on my old laptop, and can check tonight. |
Shoggin
| Posted on Thursday, September 06, 2018 - 01:25 pm: |
|
If you are using the simple ECMDroid it's in ECM parameters/fan settings. You can set key off, fan off speed based fan control, and temps there |
|