Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Shawns
| Posted on Thursday, April 07, 2016 - 04:15 pm: |
|
Does anyone have the specs for drilling the rotor? I can't seem to find it in the older threads |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Zhen13
| Posted on Thursday, April 07, 2016 - 04:23 pm: |
|
I don't have the specs. But the drilled rotors are available for $360 ish from EBR thru LAP http://www.liquidap.com/ebrparts/ |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bubba_
| Posted on Thursday, April 07, 2016 - 05:30 pm: |
|
there was a thread recently about it.. i'll find it. the OP took his rotor to a machinist and made a custom oil jet. he would have specifics on his at least. |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bubba_
| Posted on Thursday, April 07, 2016 - 05:44 pm: |
|
regarding oiling rotor at the end of this thread, Flybysr1 posted some pics of his custom rotor. i expect i'll do something similar at some point. i'm guessing, but i expect the hole is in the .07mm to 1mm range |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Dennis_c
| Posted on Thursday, April 07, 2016 - 08:47 pm: |
|
Top of hole 1/4" about 1/2 way through change to #71 drill bit. To big you will starve the upper end of oil. EBR gave me the hole size the 71 |
|