| Author | Message | ||
     Germblast |
I was doing some maintenance n the bike today and I noticed this thing that is held into place by a bracket as part of the lower air box assembly. Not sure what it is, but nothing was attached the connection with the green o-ring.  | ||
| Sprintst |
Air pressure sensor, aka BARO sensor (Message edited by sprintst on July 24, 2015) | ||
| Froggy |
Yep Barometric pressure sensor, nothing is attached to it. | ||
| Germblast |
Okay, thanks. Just seemed really odd to just be sitting out there with nothing attached to it. Any recommended mods to the bike? its a 2008 if that matters. I just picked it up a few months ago and am going to clean the throttle body butterflies like the other post using seafoam spray and see if that cures my low speed hiccup. Thanks again | ||
| Stimbrell |
Yours is fitted upside down however. The cable connector goes in to that clip. | ||
| Stimbrell |
 | ||
| Upaero |
Somebody else just asked for mod recommendations in case you didn't see this thread: http://www.badweatherbikers.com/buell/messages/290 431/765681.html?1437843837 | ||
| Germblast |
Thanks for the info about being installed incorrectly...I'll be back in there next week when I change out the air filter. Upaero - thanks for the link, but have one new question now....what does it mean to remove the solenoid? I will try to do a search later today, but if someone has the link already that would be great. Thanks again Jeremy} | ||
| Ponti1 |
Active Intake Solenoid removal thread here: http://www.badweatherbikers.com/buell/messages/290 431/490767.html |
