| Author | Message | ||
     Shawns |
09 1125 CR. Had errors for tps and iac, replaced both off of a spare throttle body assay. Idled fine for the first ride, about 20 miles. Left work, started her up idled fine for about 30 -60 seconds and then stalled. Started right up and stalled again. Runs fine at higher RPMS. Has EBR race dcm and Keda RT3 exhaust. Tried to adjust idle through cables, no change. Fuel pressure is within the norm, starts at around 80psi and levels out around 60psi during idle. AFV is at 100, charging is fine just did an upgrade. checked the grounds, they are tight and clean. I am waiting for the full version of ECMSPY to try and make adjustments if necessary, defiantly gonna need some help on that . I am at a bit of a loss. | ||
| Ratbuell |
When you replaced the parts, did you do a TPS reset per the manual to baseline the new sensors to the ECM? | ||
| Easylarveur |
Have a look there: http://www.badweatherbikers.com/buell/messages/384 2/B074.pdf You should not disassemble the TPS, but rather swap the whole throttle body. (Message edited by Easylarveur on September 25, 2014) | ||
| Shawns |
I did do a tps reset when I changed them out. I am having the same idle issues as before, just without a code now (Message edited by Shawns on September 25, 2014) | ||
| Dwp138 |
did the ecm you bought fix the issue? | ||
| Shawns |
Haven't done that yet, waiting for a factory one to come in. Hopefully in a few days. |
