| Author | Message | ||
     01fxdx |
My 09 cr, ebr ecu and fmf pipe likes to spit and die quite often now. Used to be once in awhile, now just about all the time. No codes, adequate fuel pressure and plugs look good. Idle rpm seems normal, just coughs and dies. | ||
| Pmjolly |
Mine was stalling at idle. It would idle slower and slower, then just die. I got no codes. I cleaned out the idle air control, and it is good as new. I opened up the air box, removed the air filter, and sprayed B12 Chemtool into the pinhole opening below the butterflies on each intake. I also sprayed it from the other direction, down the little rubber hose that comes up into the bottom of the airbox. I did this both with it running, and not running. Be very careful. If you spray it down that tube without the engine running, then try to start it, it will spit a bunch of B12 back at you when you crank it. I learned this the hard way. It splashed down the side of my frame, and etched the powder coating before I could clean it off. |
