G oog le Buell 1125R Forum | Login/out | Topics | Search | Custodians | Register | Edit Profile


Buell Forum » 1125R Superbike Board » Archive through September 17, 2012 » I think I need a alternator....HELP!!! « Previous Next »

Author Message
Top of pagePrevious messageNext messageBottom of page Link to this message

Dre_001
Posted on Monday, August 20, 2012 - 06:38 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Hi,

My 08 1125R is dead and I think I need a Alternator...

I put in a brand new battery and rode it for couple of days. While riding it shut off and would not turn back on. Used a jumper box it started ran for 5min sounded rough and died..

Anyone have this happen to them...or know what the hell is wrong?
Top of pagePrevious messageNext messageBottom of page Link to this message

Sprintst
Posted on Monday, August 20, 2012 - 07:13 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Yeah, we don't have alternators, we have stators. You may just have a bad voltage regulator, which is much easier and cheaper to repair

the 08's don't have the stator issues later years do

Sounds pretty clear it's not charging, there are several possible causes, so don't freak yet.

I'd post this in the charging subforum

(Message edited by sprintst on August 20, 2012)
Top of pagePrevious messageNext messageBottom of page Link to this message

Boogiman1981
Posted on Monday, August 20, 2012 - 08:07 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Bad reg is most likely with an 08
Top of pagePrevious messageNext messageBottom of page Link to this message

Redcrrider
Posted on Monday, August 20, 2012 - 09:21 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Completely charge the battery, start the bike, unplug stator plug from voltage regulator. Using a multimeter, set to AC, connect the two leads to 2 stator wires at a time. We'll call the three wires A, B, C. Check voltage at idle and at 3k rpms between A-B, B-C and A-C. You should see 15-20 volts at idle and around 40-45v above 3k. More important than the number is that all three legs are the same. You'll know if one is bad right away. If they all check out, then it's most likely your voltage regulator. Get an aftermarket mosfet regulator.
Top of pagePrevious messageNext messageBottom of page Link to this message

Boogiman1981
Posted on Monday, August 20, 2012 - 10:01 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Only reason to go aftermarket for an 08 is if it's cheaper. The VR that's on the 08's is fine design wise but there have been a few failures, mine being one of them. Since it was replaced it's gone 24k more trouble free miles.
Top of pagePrevious messageNext messageBottom of page Link to this message

Dre_001
Posted on Monday, August 20, 2012 - 11:08 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

So you guys think its the Voltage Regulator?? If so where can i buy one and is it hard to replace?
Top of pagePrevious messageNext messageBottom of page Link to this message

Tbowdre
Posted on Monday, August 20, 2012 - 11:51 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

check out the classified section. I have a brand new, never installed, OEM R/R for sale. I wanted it with me last year (just in case) when I went on a road trip. I dont need it anymore as my charging system is all aftermarket now.

send a pm if interested
Top of pagePrevious messageNext messageBottom of page Link to this message

Sprintst
Posted on Tuesday, August 21, 2012 - 08:34 am:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Dre - highly suggest you buy the factory repair manual, electrical manual and parts catalog while you still can


This will allow you to diagnose problems, evaluate the difficulty of the repair, and order parts by number only.
Top of pagePrevious messageNext messageBottom of page Link to this message

Jaredc01
Posted on Tuesday, August 21, 2012 - 12:39 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

Sprintst, on that same note I've been interested in all three of those for my 08' since I bought it... Where's a good (legal) place to get them anymore?
Top of pagePrevious messageNext messageBottom of page Link to this message

Zac4mac
Posted on Tuesday, August 21, 2012 - 02:22 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

HD/Buell dealer/service center
Top of pagePrevious messageNext messageBottom of page Link to this message

Sprintst
Posted on Tuesday, August 21, 2012 - 02:58 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

I got mine off ebay, there are legit dealers that list them.

My last parts order was from Lake Side Harley, good prices and service

http://www.lshd1.com/servlet/StoreFront
Top of pagePrevious messageNext messageBottom of page Link to this message

Dre_001
Posted on Wednesday, August 22, 2012 - 03:13 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

How hard is it to replace the Voltage Regulator? Would I need special tools or can i do it myself in a couple of hours?
Top of pagePrevious messageNext messageBottom of page Link to this message

Boogiman1981
Posted on Wednesday, August 22, 2012 - 03:20 pm:   Edit Post Delete Post View Post/Check IP Print Post    Move Post (Custodian/Admin Only) Ban Poster IP (Custodian/Admin only)

no special tools. the seat comes off with a T-30 the R/R is held on by 2 10-12mm can't recall exact size. wiring is 2 plugs that lock together depress the release tab and pull apart. really shouldn't take more than about 20 min
« Previous Next »

Add Your Message Here
Post:
Bold text Italics Underline Create a hyperlink Insert a clipart image

Username: Posting Information:
This is a public posting area. Enter your username and password if you have an account. Otherwise, enter your full name as your username and leave the password blank. Your e-mail address is optional.
Password:
E-mail:
Options: Post as "Anonymous" (Valid reason required. Abusers will be exposed. If unsure, ask.)
Enable HTML code in message
Automatically activate URLs in message
Action:

Topics | Last Day | Tree View | Search | User List | Help/Instructions | Rules | Program Credits Administration