| Author | Message | ||
     Jossi |
Hi i have coolant leak from the small hole on the left side of waterpump , is that hole for overpressure or is the waterpump gone its not a big leak . After i installed the EBR ecm i discovered som veird thing when i start bike it runs ok but when i take off it drops in rpm just for a second or two then it wakes up again i like the EBR ecm bike runs great 1125r -08 Regards Jossi | ||
| 1125rcya |
http://www.badweatherbikers.com/buell/messages/290 431/566368.html For your idle/running issue. | ||
| Jossi |
Hi any ideas for the waterpump issue ? is it gone when you have a leak from the small hole on the left side | ||
| Geedee |
Hi Jossi. My bike had the waterpump leak after only 300 Km, and was covered by warranty. Workshop told me it was a 10 hour job, so I'm glad I didn't have to pay for it. I think it is a known issue. Some of the 1125's I have seen show water stains running from the pump hole, but the owners may be unaware of it. Look in the archives here on Badweb. I recall some mention that in some cases the leak sealed itself after time, but my leak was quite major. Gary | ||
| Lampo |
Try flushing out the cooling system & install new coolant, I had the same weep and that cured it for me. | ||
| Jossi |
Hi and thanks , i have warranty on the bike workshop should fix this issue i have drive only 1000km with the bike | ||
| Macca_uk |
There is a seal modification on later bikes, please ensure the stealer orders & fits the later seal, yes its a motor rotate to fit & the small hole is a 'witness hole' specifically designed to stop the leaking water entering the oil side & thus showing the owner he has a problem. Mine was done under warranty though sometimes they do seal after use (normally shows after the bike has been laid up for a while) | ||
| Sportster_mann |
Looks like the water pump on my CR is leaking - and it's a 2010MY - so much for upgraded seals ... Has anybody managed to replace the seals without rotating the motor ? |
