| Author | Message | ||
     Budgolf |
I'm needing a width measurement of the swingarm at it's pivot point, outside to outside, where the pivot shaft goes thru it. | ||
| Bueller4ever |
Well mine is still on the bike, so it's hard to get an accurate measurement. My rough measurement is 5.5 inches. | ||
| Jcjohnson33 |
from what I can gather measuring on the bike it's like 5.5 inches on my '09 1125R | ||
| Nillaice |
if you NEED exact measurements i have one i can get down from my attic ... | ||
| Smoke |
i will check my removed one. metric or imperial measurement? tim | ||
| Budgolf |
Imperial please! | ||
| Torquaholic |
I just measured mine three times, different points around the leading edges. My best repeated take without using a larger caliper is 5 & 5/16". The picture below may or may not help. If this is for a swingarm fabrication measurement, don't just take my word for it. Please pull your swingarm and measure it. hope this helps though.  |
