| Author | Message | ||
     Green1 |
What is the proper repair,is it just seals or the seals and piston.Local shop is saying that it may be just the seals and have to take it apart and look before they order parts.Is there a service bullitin saying what the repair is other than the info that comes with the kit #x2086.1am | ||
| Jdugger |
Could be just seals, but likely should be seals and slave piston. To me knowledge, you do have to take it apart (and thus drop the fluid) to diagnose. You don't have to pull the clutch cover necessarily -- but watch out when you remove that center nut the whole assembly can spring out on you spitting fluid everywhere. I'm notorious for servicing the clutch pack without pulling the slave per the service manual. Sometimes it gets me. | ||
| Nuts4mc |
Rev A (original cover) = soft cylinder and hard piston (piston eats away at cylinder...the fluid leaks out) fix is get Rev B kit (Hard Cylinder, soft piston) If you got rev B kit installed - then it's seal replacement time... and yes - be careful of the spring loaded piston AFTER you remove the spherical nut - sometimes the hydraulic "seal/containment" will hold the piston in place until some air leaks in and then..."sprong" parts and fluid go flying- not fun as the DOT4 eats paint - the spring is not too strong - just strong enough to send things flying - if you do the work yourself - make sure the cylinder is clean and smooth otherwise the seals will fail again. | ||
| Jersey_thunder |
what cover do you have? if it's the B cover...just do the piston seals...should be fine after that...easy repair.. | ||
| Jersey_thunder |
i have a extra x2086.1am in stock | ||
| Green1 |
Its still under warranty and never been done so i'll assume i have the A cover,is there a way to tell them apart | ||
| Badlionsfan |
If it's an 08 that's never been done, it's cover A. The puck will look like the one on the other side on the stator cover. 09 and up came with B, and the puck is larger than on the stator side. | ||
| Rafagk |
Anyone has the part number for the piston seals? | ||
| Brumbear |
I believe Jersey Thunder has the seal kits I am not sure get them in yet Tony? | ||
| Jersey_thunder |
i have the x2086.1am rebuild up grade kit in stock... or you just want the piston seals? jt (Message edited by jersey_thunder on January 31, 2011) | ||
| Budgolf |
Whats the price on those kits Jersey? | ||
| Zac4mac |
Good on ya there Tony, good thing to stock. OT - gotta strip Loretta for paint soon. When she's done, gotta decide where to put your team decal. I'll be proud to show it off! Z | ||
| Jersey_thunder |
Z thank man...budgolf when i get to the shop i'll get you a price...we alway try to have a kit at the track...never know  anyone else want a decal just pm me with address... (Message edited by jersey_thunder on February 01, 2011) | ||
| Jersey_thunder |
THE KIT IS $232.00 IN STOCK... | ||
| Rafagk |
I ride a 2009 CR, it has a Rev. B cover. I believe that just the Piston linings(PN CR0001.3AM and CR0002.3AM) would work. Thanks. | ||
| Jersey_thunder |
i would recomend just replacing the 2 piston seals first...we have those also quike, easy...inexpensive the kit will fix it but may not be nessary..try a asprin before brain surgry |
