| Author | Message | ||
     Wbrisett |
Kwik Lift http://www.newportcycleparts.com/categories/access ories/lp_stands.htm Somebody is sell one where my wife works dirt cheap. But I can't quite tell if this something that I can use it on the Uly and the 1125CR. It comes with 16 & 21 mm pins, but I can't quite figure out if that would work on either the Uly or the 1125CR. Anybody got a clue? Wayne | ||
| Froggy |
I am not sure which stand you specifically are talking about, but the spool one should work on your CR. Be careful, some spool stands can scratch the swingarm. Also, your Uly lacks spools. | ||
| Wbrisett |
The stand in question is the Kwik Lift about half-way down the page. I realize there aren't any spools on the Uly, and this doesn't use spools, but a pin in the fork (like Pit Bull is doing from what I can tell). | ||
| 1_mike |
Um...one can always spread the stand as required. On a rear stand I bought, it was so strong I had to use a floor jack to widen the stand legs to fit my CR. This method is for those that don't want to spend the big bucks anyway...! Mike | ||
| Ratbuell |
My pit bull does lift the front end with a pin, inserted into the lower tree. It also specifically says "do not use without rear stand in place". So I, of course, tried it that way. "unstable" didn't begin to describe it. But with my rear stand, and the correct pin (one fits my tubers; one for XB; one for 1125), I love them! I got all of 'em from American Sport Bike and couldn't be happier. | ||
| Wbrisett |
one of the local Buell riders found that the hole in the CR and Uly is 19 mm, so the Kwik Lift won't work since it only has pins for 21 and 16 mm. Wayne |
