| Author | Message | ||
     Jayz |
Hi all, I've just installed E.B.R ECM (fuel pump + barkers) and when i get into diag mode, i found these errors: - TPS SYS ERR - FUELPMP SYS ERR - FUEL PR SYS ERR - IAC SYS ERR - TIPOVER SYS ERR - ACT INT SYS ERR - IAT SYS ERROR - RT FAN SYS ERR I haven't ridden the bike yet but have run it and let it idle for 10 mins and it seems fine. Has anyone else experienced this? Should i be worried? Look forward to your responses... | ||
| Jules |
That's normal, Erik Buell Racing don't normally have the time to reset all of the historic codes before shipping. They'll go away after 50 cycles. If you get a new "genuine" fault the EM light will stay on. | ||
| Jayz |
Thanks Jules. phew! Would turning the key on and off considered a cycle or do i have to actually start the bike? | ||
| Mountainstorm |
Have to start it and let it warm up. I would not worry about the codes at all. They will erase on their own and will cause no issues. | ||
| Jayz |
Thanks mate. | ||
| Milleniumx1 |
Same when I installed mine, but I was expecting it (based on posts here) so it didn't alarm me. I never had any new 'real' ones occur, and they all cleared after 50 cycles. I wasn't counting them exactly, but 50 seems about right ... Mike | ||
| Froggy |
Same thing happens when you get your stock ECM updated at the dealer, but usually they clear them out since they are already connected.  |
