Author |
Message |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Cityracer
| Posted on Saturday, November 07, 2009 - 11:28 am: |
|
Hey Bob, What was the Dzus fastener size that you used? My local speed shop has an infinite amount of sizes for post width, length and depth for the rivet plate. I appreciate it. Kevin |
![Top of page](http://www.badweatherbikers.com/buell/icons/mark_top.gif) ![Previous message](http://www.badweatherbikers.com/buell/icons/mark_up.gif) ![Next message](http://www.badweatherbikers.com/buell/icons/mark_down.gif) ![Link to this message](http://www.badweatherbikers.com/buell/icons/link-up.gif)
Bob_thompson
| Posted on Saturday, November 07, 2009 - 01:02 pm: |
|
Kevin(Cityracer), I used 3/8" which was the total thickness of the fairing and that of my brackets. Left a little room for a thin washer to spread the load on the fiberglass. They were also 1/4" hole size. Bob (Message edited by bob_thompson on November 07, 2009) |
|