| Author | Message | ||
     Hitman44139 |
Will the rear section from a xb12 r fit the 1125??? | ||
| Buellborn |
Someone here did it and it LOOKED GREAT! I can't seem to find the thread. | ||
| Fresnobuell |
What's the difference? | ||
| Buellborn |
I was thinking the RR tail, sorry. | ||
| Oddball |
I thought all those were photoshops still. I think it would require some fabbing to the tail section's upper mounting points. Looks like they are in a different position than on the XB. There are enough motivated people around someone will do it. | ||
| Hitman44139 |
So size wise its the same just mounting wise it needs modification....... | ||
| Oddball |
I think so. Perhaps court or an anon could say if that is the case. (Message edited by Oddball on September 24, 2008) | ||
| Zac4mac |
A very small difference was noted late last year. Key orientation is off by 90˚ btw the two. I don't know of any other diff, but haven't tried swapping. I know the top airbox and seats are a straight swap. Z | ||
| No_rice |
it will fit. thats whats on the back of my 1125. a tail off of one of my xb's. only problems are that you have to trim the bottom front mounting tabs as they will hit the footpeg mounts a bit and not allow the holes to line up. the you also have to cut a new notch in the hole for the pillion lock as the lock cylinder sits turned a different direction on the 1125 then it does on the firebolts. very simple fixes. |
