| Author | Message | ||
     Williep13 |
I have a set of heads I was experimenting with on my drag bike never quite finished the experiment but know it will work because I did it on another bike. The heads are from a mid 90's Sportster should work on any 03 and earlier carb sportster and buell engine (you would have to do your on research). I was going to put them on a FI and just tap the heads to put the heat sensor in them. The intake and exhaust ports on these are HUGE! The intake is an 190 valve and the exhaust is a 160. The valves, springs, guides, seals are all brand new. The bad part is my experiment is welding up the squish area so you can run a flat top piston and be around 11.5:1 compression ratio without having tons of $ is expensive pistons and heads and then having clearance issues. This does work you just have to finish the project touch up some of the welding and then grind them back down and deck them. One of the pictures show where I have halfway did this to one side of the head. As I said before the valves, springs, guides, etc are new and not cheap ones. The heads can take a cam with about 650 lift but you will have to check piston clearance. I am looking to get about $400 out of them I have way over that in them. If interested call or text because I do not have time to check the website daily. Will (704)995-1356      | ||
| Williep13 |
sfs | ||
| Buelliedan |
I would give you $250 for them |
