| Author | Message | ||
     Dannybuell |
Might be wrong place to post. I saw these at the swap meet today and wanted to share. A new spotless header for a tube frame. the part number on the piece is so101.9a. I also found what appears to be a tube frame belly pan. Almost virgin one back corner is cracked broken the size of a quarter. Are those worth anything? A blue buell labeled S1 race module in an unopened box. If there is any interest, I can go back across town for you tuber collectors. | ||
| Brinnutz |
If that head is any cheaper than this, it's a good deal! http://cgi.ebay.com/ebaymotors/Buell-1997-S3-Exhau st-Header-S0101-9A-_W0QQcmdZViewItemQQhashZitem5ad 88bc2e5QQitemZ390180094693QQptZMotorcyclesQ5fParts Q5fAccessories What were they asking for that belly pan? I might be interested. | ||
| Dannybuell |
That is the same header. I did not ask. If you have a belly pan picture I can confirm what I saw. | ||
| Brinnutz |
 That's not the Buell part, but should look a bit similar (Message edited by brinnutz on April 24, 2010) | ||
| Hybridmomentspass |
So.....is there anything someone could do about getting these items? Or are you just posting what you saw at a random swap meet? Is it going on tomorrow to where you could purchase these and ship them to someone? | ||
| Dannybuell |
The belly pan I saw looks similar (white) but its sides reach up much higher Yes I have the sellers phone and I will be calling him when the meet is over. (Message edited by dannybuell on April 25, 2010) | ||
| Dinuns1 |
pm sent | ||
| Firstbuell |
OP, thanx for posting this - any parts sold means everyone all 'round owes you big-time ! | ||
| Dannybuell |
Any idea what these are worth? | ||
| Dannybuell |
I just went to the seller's house and took another look the belly pan. It is made by air-tech has a horizontal bulge (header) on the right side and a bump on the left side there is a build date glassed into the inside, looked like 1-?-96. there was a trailing tail on the right side at the rear. Something I did not notice the first time I saw it was the two small holes were drilled on one side. It clearly has not been mounted though. The seller wants 400.00 for the pan and 100.00 for the ECM. I declined. I took some pictures of the pan if anyone is still interested. I took another look at the airtech site and it is the lower 1/2 of their GP kit. (Message edited by dannybuell on May 02, 2010) |
