| Author | Message | ||
     Johnnymceldoo |
I made a tail lift for my 05 xb12s. Its made out of D2 steel and is an 1/8 thick. It will lift the tail 3-3.5 inches. I milled slots instead of holes on one end so there is some adjustability. I had them on my bike for a couple months but at 5'9" with the high seat I can barely reach. Iam looking to trade even for a used xb12 muffler. A little rust and a small dent here or there ok. Iam in Ohio | ||
| Buell666 |
do you have pics? how much do you want for them? i dont have a stock muffler anymore to trade. | ||
| Tq_freak |
I got a Muffler and have been looking for a tail lift can you send me some pictures of the blocks on and off the bike? | ||
| Johnnymceldoo |
I'll get some pics and post them up tomorrow night. I could make another set but dont know how much just yet. I'll let you know tomorrow. | ||
| Johnnymceldoo |
Heres the before and after pics:  Heres what the lift consists of:  When I made this I recorded about a 3" height increase if I remember correctly. | ||
| Buell666 |
hook me up dude. how much? | ||
| Cyclonemduece |
is it just me or is that like 4 dollars worth of stuff? | ||
| Con10der |
^i disagree.....maybe $3 | ||
| Johnnymceldoo |
Buell666, I'll let it go for $45 shipped priority. Cyclonemduece and Con10der, you can have it $60 plus shipping fees. | ||
| Con10der |
^^its ok....i have my own for under $3 | ||
| Johnnymceldoo |
You can make your own for cheap no doubt. When you add quality metal to the equation and cnc programming the price goes up. Then add what your time is worth and shipping costs. I wish there were rules on this site about trashing a guys sales thread. You think its too expensive? Fine then dont buy it and move on. Dont come in my thread and whine like petty bitches about price. Con10der, I see your in cali. You have much bigger things to bitch about than the price of my parts. Would $45 even cover half the cost renewing your plates for a year? |
