| Author | Message | ||
     Doncasto |
 I have 12 sets of motor mount bolts that available at cost. They are an upgrade from the HD/Buell F911 offering . . .parts #AAO722.1CBZ (bolt 7/16-14 X 2 3/4 inch, $8.47 ea.) and #BA0714.1CBZ (washer 7/16, $.98 ea). I have sent out several dozen sets of these bolts in past years and have not heard any reports of breakage . . .an apparent problem with the F911 bolts. For a more comprehensive explanation of what the Chromate CIC200 fasteners system is about . . http://www.chromate.com/AgentCatalogWeb/Section%2010.pdf These bolts have a high tech coating that should eliminate any corrosive factors in bolt failures. The bolts are 1/4 inch longer than the HD/Buell bolts and may require trimming with a Dremel tool and/or grinder. Price per pair . . .$12.25, includes 2 bolts, two extra thick grade 8 washers, packing and USPS First Class postage. | ||
| Brinnutz |
In for a set! I'll PM later, but I want at least one set | ||
| Devdawg |
In for one set. Will send address via PM. How do you want payment? | ||
| Buell_lee |
I'll take 2 sets if you don't mind sending them to Australia I'll PM you later if that's OK | ||
| Doncasto |
Lee, No worries, although the shipping will be a little more methinks. PM me your address and I will send them off and get back to you with the total including shipping. I will be sending out 8 sets in tomorrow's mail .. .only 4 sets remaining on this order. | ||
| Brinnutz |
pm'ed finally. | ||
| Doncasto |
2 sets of bolts remaining . . .4 if I kick in the ones I held for my S2's. If there is sufficient interest I will reorder and can have additional sets available next week. Don | ||
| Fasted |
forgive my ignorance....i have a 99 m2. when the iso gets replaced, no doubt there is an upgrade part. if these bolts are applicable to my bike, and that part, i'll take a set as well, please.. | ||
| Doncasto |
Fasted, If you are it is a replacement of your front isolator that you are doing . . ., if I recall correctly it can be done without removing and replacing the bolts from the mount to the head. However, many would argue that with the failures noted in the stock bolts it is best to replace the stock bolts as a preemptive measure. Once they have sheared off you will be replacing them in any case . . .and in some cases you will lose the mount and/or have damage to the head as well. YMMV . . . Don | ||
| Doncasto |
As of this morning I have 3 sets of bolts left, all others have been sent out to Buellists across the globe. Thanks. . .Mark McCarthy for sending in his check! Don | ||
| F_skinner |
Don, I will take your last three sets.... I will PM you. Frank | ||
| Doncasto |
I will be happy to order more from Chromate as the needs of my fellow Badwebsters becomes apparent. Thanks, Don | ||
| Brinnutz |
Don, Your check is in the mail, btw. Mailed out Friday...Sorry for the delay! |
