Author |
Message |
Midnightrider
| Posted on Thursday, February 07, 2008 - 10:41 pm: |
|
Didn't need the "low" part but I wanted it for the gel pad. Found out I was happier with the stock seat and a "butt buffer" pad. Probably less than 100 miles on the saddle. I did, however, drill three 3/4 inch holes in the air dam underneath the seat when I was experimenting with heat flow issues. These have been plugged with threaded pvc fittings. No structural issues - just cosmetic. $125 |
Midnightrider
| Posted on Thursday, February 07, 2008 - 10:45 pm: |
|
this is an early pic when i wanted the air to flow through. i replaced the fittings with smaller black caps
|
|