| Author | Message | ||
     Kerryb |
I guess I'll know more as soon as I open it up and have a look, but does anyone have any ideas so far? Earlier this week I put in a new stator. I took it on 4 short test rides, longest about 10 miles. All seemed good and everything checked out correct. I changed the oil and filt and washed it. After the wash, when I turned the key, nothing. Battery voltage dropped significantly so I removed the battery charged it overnight. This morning, the battery had a good charge so I tried it again and got the same (no lights no clicks) results. It's not reading any voltage while the battery is installed? I reread the svc manual for stator check and the stator checks out good. The fuses all test good too? (Message edited by kerryb on September 19, 2015) | ||
| Ezblast |
Regulator, needed to be replaced with stator, or water in ignition connector onside of bike, make sure plug wire tight as well. EZ | ||
| Kerryb |
well, this is not good. Something must have got wet and shorted when I tried to start the bike yesterday. I charged the battery, 12.5v, put it in the bike, it would not read any volts. Took the battery out of the bike, it read 10.2v. I have the battery charging again. EZ, I have a new voltage regulator that I'll put in and see what happens. (Message edited by kerryb on September 19, 2015) | ||
| Kerryb |
it is a dead short to ground, in the starter. I'll try to get a starter off of Ebay. |
